How to Replace Front Control Arm Bushings on a Daewoo Lanos?
Replacing the front control arm bushings on a Daewoo Lanos is a job you can do yourself with a basic set of tools. In this article, we'll walk through a step-by-step guide so you can handle the job quickly and without unnecessary hassle. If you're still deciding which type of bushings suit your driving style, check our article on choosing the right bushings for the Daewoo Lanos before you start.
Getting Ready
Before you start replacing the bushings, gather all the tools you'll need. You'll need:
- A wrench set (including 12mm, 13mm, and 22mm wrenches).
- A wrench or ratchet.
- An angle grinder (if needed).
- Screwdrivers.
- Lubricant (e.g., soap or automotive grease).
- A hammer (for disassembly).
- A press (for installing the parts).
Отримати консультацію по підбору деталей:
Get a consultation on choosing the right parts:
Получить консультацию по подбору деталей:
Step 1: Removing the Wheel
Before you begin, you need to remove the front wheel. Lift the car with a jack and secure it on stands for safety. Unscrew the wheel nuts and take the wheel off.
Step 2: Disconnecting the Components
Next, disconnect the control arm and other components. First, unscrew the nuts on the bolts holding the bushings. They're often seized due to corrosion, so you may need an angle grinder to cut them free.
Step 3: Removing the Ball Joint
Next, remove the ball joint. Unscrew the nut and carefully knock it loose to avoid damage. This step matters because the ball joint can get in the way of the rest of the job.
Step 4: Removing the Old Bushings
Now that the control arm is free, you can remove the old bushings. They're usually worn and may come off the arm on their own. Use a specialized tool or a hammer to remove them. If they're seized, you may need an angle grinder to cut them out. If both the bushings and the arm itself are badly worn, it's worth comparing the cost of replacing just the bushings against replacing the whole arm — see our article on whether it's better to replace just the bushings or the entire control arm.
Step 5: Installing the New Bushings
Before installing the new bushings, prepare them properly. You can use a lubricant if needed to make installation easier and help prevent damage to the part while pressing it in. Press the new bushings into the control arm using a quality press. Never use a hammer to install the new parts — doing so can damage them and shorten their service life. Using a press correctly ensures a proper fit and correct installation of the bushings.
Step 6: Reassembly
Once the new bushings are installed, put all the removed components back in place. Before tightening the nuts, lower the car back to the ground so the bushings are under their normal working load. This matters for them to seat and secure correctly.
Step 7: Final Check
Once everything is done, check that all the parts are properly installed and secured. Take the car for a short drive to make sure the new bushings are working correctly.
Replacing the front control arm bushings on a Daewoo Lanos isn't a job that requires advanced skills, but it does call for care and attention to detail. Following this step-by-step guide, you'll be able to handle the job yourself. Don't forget about safety, and double-check every connection before hitting the road. If you have any questions or need help, don't hesitate to reach out to our specialists! For general guidance that applies to other vehicles too, see our general guide to replacing bushings.
